Catalyst
Speeds up a reaction and is not used up. It gives a new path with a lower Ea.
Unit 6: Reaction Rates and Kinetics, lesson 8
A catalyst makes a reaction faster without being used up. It does this by giving the reaction a different route with a lower activation energy.
Three quick questions on ideas this lesson uses. They are not scored.
1.On a reaction-progress diagram, the activation energy is measured from the reactants up to the …
Ea is the height of the hill: reactants up to the transition state.
2.At the same temperature, a reaction with a smaller activation energy is …
A lower hill lets a larger fraction of collisions succeed.
3.ΔH for a reaction depends on …
ΔH is products minus reactants. The path between them does not matter.
Raising the temperature speeds a reaction up by giving more molecules enough energy to get over the hill. A catalyst works the other way round. It leaves the molecules alone and offers them a lower hill.
A catalyst is a substance that increases the rate of a reaction and is not used up by it. It takes part in the reaction, but it is made again before the reaction is over. So a small amount of catalyst can be used over and over.[OpenStax Chemistry 12.7]
A reaction-progress diagram with two paths from the same reactants to the same products. The solid line, without a catalyst, goes over a high hill. The dashed line, with a catalyst, goes over a lower hill. The arrow for the activation energy with the catalyst is much shorter than the arrow without it. Both paths start at the same level and end at the same level.
The catalyzed route is a different set of steps, a different mechanism, and its activation energy is lower. With a lower hill, a much larger fraction of collisions succeed at the same temperature. The rate constant goes up, and so does the rate.
Key idea
A catalyst provides a new reaction path with a lower activation energy. It is not used up.
Look again at the two ends of the diagram. The reactants are at the same energy on both paths, and so are the products. A catalyst changes the route, not the start or the finish.
Try it: what a catalyst changes
A catalyst is added to a reaction at constant temperature.
Because a catalyst is used and then made again, it shows up in a particular way when a reaction is written as steps. It is a reactant in an early step and a product in a later one.
High in the atmosphere, chlorine atoms speed up the breakdown of ozone, O3, in two steps.[OpenStax Chemistry 12.7]
OverallO3 + O → 2 O2
The chlorine atom goes in at step 1 and comes back out at step 2. It cancels when the steps are added, so it is not in the overall equation. That is the mark of a catalyst. One chlorine atom can destroy many ozone molecules, because it is free to start again each time.
ClO behaves differently. It is made in step 1 and used up in step 2. A substance like that is called an intermediate. Lesson 9 looks at intermediates closely.
Key idea
A catalyst is used up in an early step and made again in a later step. It does not appear in the overall equation.
Surface catalysts. Many catalysts are solids, and the reaction happens on their surface. Reactant molecules stick to the surface. That weakens their bonds and holds them in a good position to react. The products then leave and the surface is free again. The catalytic converter in a car works this way. Exhaust gases pass over metals such as platinum, which help turn carbon monoxide and nitrogen oxides into less harmful gases.[OpenStax Chemistry 12.7]
Acid–base catalysts. In solution, an acid or a base can act as a catalyst. A reactant gains or loses a proton, H+, which turns it into a new intermediate that reacts more easily. The proton is given back at the end.
Enzymes. Enzymes are the catalysts of living things. Each one is a large protein with a pocket called the active site. The reactant, called the substrate, fits into the active site and is held there in the right orientation. Bonds are strained and the reaction goes through a lower-energy path. Without enzymes, most reactions in your cells would be far too slow to keep you alive.[OpenStax Chemistry 12.7]
A catalyst takes part in the mechanism, so its concentration can appear in the rate law, even though it is not in the overall equation. If you see a substance in a rate law that is not a reactant, it is probably a catalyst.
Adding a catalyst is one of the few ways to change a rate constant. Changing a concentration changes the rate, but not k. Only two things change k: the temperature and the activation energy. A catalyst changes the activation energy by changing the path.
Common mistake
A catalyst does not lower the hill of the same route. It opens a different route with a lower hill. It does not change ΔH, the equilibrium constant or how much product forms in the end.
Strategy
To tell a catalyst from an intermediate in a list of steps, follow when each one appears.
Neither one appears in the overall equation.
Speeds up a reaction and is not used up. It gives a new path with a lower Ea.
ΔH, the reactants, the products and the amount of product.
A catalyst is a reactant in an early step and a product in a later step. An intermediate is the other way round.
Surface catalysts, acid–base catalysts and enzymes.
A catalyst makes k larger, because the activation energy is lower.
0 of 8 solved
Check each answer as you go. If you get stuck, open the hint first, then the text solution.
How does a catalyst increase the rate of a reaction?
Think about the hill, not the molecules.
The diagram shows a reaction with and without a catalyst. Which statement is correct?
A reaction-progress diagram with two paths. A solid line goes over a high hill and a dashed line goes over a lower hill. Both start at the same reactant level and end at the same product level, which is higher than the reactants.
Which path has the lower hill? Where do the two paths start and end?
A catalyst is added to a reaction. For each quantity, say what happens.
(a) Activation energy
(b) ΔH
(c) Rate constant
A catalyst changes the path, not the two ends.
A reaction happens in two steps. Step 1: A + C → AC. Step 2: AC + B → AB + C. Which species is the catalyst?
Look for something used in step 1 and made again in step 2.
In the same two steps (Step 1: A + C → AC. Step 2: AC + B → AB + C), what is AC?
AC is made first and used up later.
In a car's catalytic converter, exhaust gases react on the surface of a solid metal. What kind of catalysis is this?
Where does the reaction happen?
What is the role of the active site of an enzyme?
An enzyme is a catalyst.
A student says, “A catalyst gives a larger yield of product.” Is the student correct?
What happens to the reverse reaction?
Want another question on this lesson? Each one is made fresh, so you can keep going until it feels easy.
Sections read: 0%. Practice: 0 answered.