AP ChemistryAll courses
Reference

Unit 6: Reaction Rates and Kinetics, lesson 8

Catalysts

A catalyst makes a reaction faster without being used up. It does this by giving the reaction a different route with a lower activation energy.

  • About 15 minutes
  • 5 sections
  • 8 practice questions
  • Narrated

After this lesson you can

  • Explain how a catalyst increases a rate, using activation energy.
  • Show a catalyzed and an uncatalyzed path on a reaction-progress diagram.
  • List what a catalyst does not change.
  • Pick out a catalyst in a set of reaction steps.
  • Describe surface catalysts, acid–base catalysts and enzymes.

Warm-up check

Three quick questions on ideas this lesson uses. They are not scored.

  1. 1.On a reaction-progress diagram, the activation energy is measured from the reactants up to the …

    Question 1: choose one
    See the answer

    Ea is the height of the hill: reactants up to the transition state.

  2. 2.At the same temperature, a reaction with a smaller activation energy is …

    Question 2: choose one
    See the answer

    A lower hill lets a larger fraction of collisions succeed.

  3. 3.ΔH for a reaction depends on …

    Question 3: choose one
    See the answer

    ΔH is products minus reactants. The path between them does not matter.

A different route

Raising the temperature speeds a reaction up by giving more molecules enough energy to get over the hill. A catalyst works the other way round. It leaves the molecules alone and offers them a lower hill.

A catalyst is a substance that increases the rate of a reaction and is not used up by it. It takes part in the reaction, but it is made again before the reaction is over. So a small amount of catalyst can be used over and over.[OpenStax Chemistry 12.7]

Reaction-progress diagramA reaction-progress diagram with two paths from the same reactants to the same products. The solid line, without a catalyst, goes over a high hill. The dashed line, with a catalyst, goes over a lower hill. The arrow for the activation energy with the catalyst is much shorter than the arrow without it. Both paths start at the same level and end at the same level.Reaction progressEnergyreactantsproductsEa​Ea​ with catalyst
The same reaction with and without a catalyst. The dashed path is the catalyzed one.
Describe this diagram

A reaction-progress diagram with two paths from the same reactants to the same products. The solid line, without a catalyst, goes over a high hill. The dashed line, with a catalyst, goes over a lower hill. The arrow for the activation energy with the catalyst is much shorter than the arrow without it. Both paths start at the same level and end at the same level.

The catalyzed route is a different set of steps, a different mechanism, and its activation energy is lower. With a lower hill, a much larger fraction of collisions succeed at the same temperature. The rate constant goes up, and so does the rate.

Key idea

A catalyst provides a new reaction path with a lower activation energy. It is not used up.

What a catalyst does not change

Look again at the two ends of the diagram. The reactants are at the same energy on both paths, and so are the products. A catalyst changes the route, not the start or the finish.

  • ΔH is the same. The reaction releases or absorbs the same amount of energy.
  • The products are the same, and you get the same amount of them. You just get them sooner.
  • The reverse reaction speeds up too. The hill is lower from both sides.
  • The energy of the molecules is the same. A catalyst does not make collisions harder.

Try it: what a catalyst changes

A catalyst is added to a reaction at constant temperature.

Activation energy
ΔH of the reaction
Rate constant, k
Average kinetic energy of the molecules
Show the reasoning
  • Activation energy: decreases. The catalyzed path has a lower hill.
  • ΔH of the reaction: stays the same. Reactants and products are unchanged, so ΔH is unchanged.
  • Rate constant, k: increases. A lower Ea gives a larger k.
  • Average kinetic energy of the molecules: stays the same. That depends only on temperature.

Spotting a catalyst in the steps

Because a catalyst is used and then made again, it shows up in a particular way when a reaction is written as steps. It is a reactant in an early step and a product in a later one.

High in the atmosphere, chlorine atoms speed up the breakdown of ozone, O3, in two steps.[OpenStax Chemistry 12.7]

  1. Step 1Cl + O3 → ClO + O2
  2. Step 2ClO + O → Cl + O2

OverallO3 + O → 2 O2

Chlorine atoms catalyze the breakdown of ozone.

The chlorine atom goes in at step 1 and comes back out at step 2. It cancels when the steps are added, so it is not in the overall equation. That is the mark of a catalyst. One chlorine atom can destroy many ozone molecules, because it is free to start again each time.

ClO behaves differently. It is made in step 1 and used up in step 2. A substance like that is called an intermediate. Lesson 9 looks at intermediates closely.

Key idea

A catalyst is used up in an early step and made again in a later step. It does not appear in the overall equation.

Three kinds of catalyst

Surface catalysts. Many catalysts are solids, and the reaction happens on their surface. Reactant molecules stick to the surface. That weakens their bonds and holds them in a good position to react. The products then leave and the surface is free again. The catalytic converter in a car works this way. Exhaust gases pass over metals such as platinum, which help turn carbon monoxide and nitrogen oxides into less harmful gases.[OpenStax Chemistry 12.7]

Acid–base catalysts. In solution, an acid or a base can act as a catalyst. A reactant gains or loses a proton, H+, which turns it into a new intermediate that reacts more easily. The proton is given back at the end.

Enzymes. Enzymes are the catalysts of living things. Each one is a large protein with a pocket called the active site. The reactant, called the substrate, fits into the active site and is held there in the right orientation. Bonds are strained and the reaction goes through a lower-energy path. Without enzymes, most reactions in your cells would be far too slow to keep you alive.[OpenStax Chemistry 12.7]

Catalysts and the rate law

A catalyst takes part in the mechanism, so its concentration can appear in the rate law, even though it is not in the overall equation. If you see a substance in a rate law that is not a reactant, it is probably a catalyst.

Adding a catalyst is one of the few ways to change a rate constant. Changing a concentration changes the rate, but not k. Only two things change k: the temperature and the activation energy. A catalyst changes the activation energy by changing the path.

Common mistake

A catalyst does not lower the hill of the same route. It opens a different route with a lower hill. It does not change ΔH, the equilibrium constant or how much product forms in the end.

Strategy

To tell a catalyst from an intermediate in a list of steps, follow when each one appears.

  • A catalyst is used up in an early step and made again later: in, then out.
  • An intermediate is made in an early step and used up later: out, then in.

Neither one appears in the overall equation.

Key concepts

Catalyst

Speeds up a reaction and is not used up. It gives a new path with a lower Ea.

Unchanged by a catalyst

ΔH, the reactants, the products and the amount of product.

In the steps

A catalyst is a reactant in an early step and a product in a later step. An intermediate is the other way round.

Kinds

Surface catalysts, acid–base catalysts and enzymes.

Rate constant

A catalyst makes k larger, because the activation energy is lower.

Practice

0 of 8 solved

Check each answer as you go. If you get stuck, open the hint first, then the text solution.

  1. Q1howOpen

    How does a catalyst increase the rate of a reaction?

    Question 1: choose one
    Hint

    Think about the hill, not the molecules.

    Text solution
    1. A catalyst does not change the energy of the molecules or of the reactants and products.
    2. It offers a different mechanism with a lower activation energy.
    3. More collisions then succeed at the same temperature.
  2. Q2diagramOpen

    The diagram shows a reaction with and without a catalyst. Which statement is correct?

    Reaction-progress diagramA reaction-progress diagram with two paths. A solid line goes over a high hill and a dashed line goes over a lower hill. Both start at the same reactant level and end at the same product level, which is higher than the reactants.Reaction progressEnergyreactantsproducts
    Describe this figure

    A reaction-progress diagram with two paths. A solid line goes over a high hill and a dashed line goes over a lower hill. Both start at the same reactant level and end at the same product level, which is higher than the reactants.

    Question 2: choose one
    Hint

    Which path has the lower hill? Where do the two paths start and end?

    Text solution
    1. The dashed path has the lower activation energy, so it is the catalyzed one.
    2. Both paths start at the same reactants and end at the same products.
    3. ΔH is the same for both.
  3. Q3unchangedOpen

    A catalyst is added to a reaction. For each quantity, say what happens.

    (a) Activation energy

    Question 3 part a: choose one

    (b) ΔH

    Question 3 part b: choose one

    (c) Rate constant

    Question 3 part c: choose one
    Hint

    A catalyst changes the path, not the two ends.

    Text solution
    1. The new path has a lower activation energy.
    2. Reactants and products are the same, so ΔH does not change.
    3. A lower activation energy gives a larger rate constant.
  4. Q4stepsOpen

    A reaction happens in two steps. Step 1: A + C → AC. Step 2: AC + B → AB + C. Which species is the catalyst?

    Question 4: choose one
    Hint

    Look for something used in step 1 and made again in step 2.

    Text solution
    1. C is a reactant in step 1 and a product in step 2.
    2. It cancels from the overall equation, A + B → AB.
    3. C is the catalyst.
  5. Q5stepsOpen

    In the same two steps (Step 1: A + C → AC. Step 2: AC + B → AB + C), what is AC?

    Question 5: choose one
    Hint

    AC is made first and used up later.

    Text solution
    1. AC is a product of step 1 and a reactant in step 2.
    2. Something made and then used up is an intermediate.
  6. Q6kindsOpen

    In a car's catalytic converter, exhaust gases react on the surface of a solid metal. What kind of catalysis is this?

    Question 6: choose one
    Hint

    Where does the reaction happen?

    Text solution
    1. The gas molecules stick to the solid, react there, and leave.
    2. A reaction on the surface of a solid catalyst is surface catalysis.
  7. Q7enzymesOpen

    What is the role of the active site of an enzyme?

    Question 7: choose one
    Hint

    An enzyme is a catalyst.

    Text solution
    1. The substrate fits into the active site.
    2. There it is held in the right orientation and its bonds are strained.
    3. That gives a path with a lower activation energy.
  8. Q8conceptsOpen

    A student says, “A catalyst gives a larger yield of product.” Is the student correct?

    Question 8: choose one
    Hint

    What happens to the reverse reaction?

    Text solution
    1. A catalyst lowers the hill for the forward and the reverse reaction alike.
    2. It does not change the reactants, the products or how much product can form.
    3. The product just forms sooner.
Moreextra practice, new numbers every timenot scored

Want another question on this lesson? Each one is made fresh, so you can keep going until it feels easy.

Sources

  • OpenStax Chemistry 12.7. Flowers, P.; Theopold, K.; Langley, R.; Robinson, W. R. Chemistry 2e, section 12.7, Catalysis. OpenStax, 2019. https://openstax.org/books/chemistry-2e/pages/12-7-catalysis

How did it go?

Sections read: 0%. Practice: 0 answered.

How was this lesson?